GATE 1998 Electronics and Communication Engineering (EC) Question Paper with Answer Key pdf is available for download. The exam was conducted by IIT Delhi . The question paper comprised a total of 104 questions from General Aptitude and Electronics and Communication Engineering (EC) topics.
GATE 1998 Electronics and Communication Engineering (EC) Question Paper with Answer Key PDF
GATE 1998 Electronics and Communication Engineering (EC) Question Paper PDF
GATE 1998 Electronics and Communication Engineering (EC) Answer Key PDF
An inward flow reaction turbine, having an outer diameter of \(1\) m, runs at \(600\) RPM. The normal component of absolute velocity at the inlet is \(10\) m/s. If the guide blade angle is \(15^{\circ}\), then the inlet vane angle of the runner is ________ degree (rounded off to 1 decimal place).
In a deep drawing operation of a rectangular sheet metal, \(30\%\) stretching in length results in \(15\%\) reduction in thickness. Assuming volume constancy, the normal anisotropy of the sheet metal is ________ (rounded off to 2 decimal places).
Convective heat transfer coefficients for Fluid 1 and Fluid 2 in a heat exchanger, as shown in the figure below, are 50 W/(m2K) and 80 W/(m2K), respectively. The inner tube is made of a material which has a thermal conductivity 386 W/(m K) for the given range of temperatures in the heat exchanger. The length of the heat exchanging surface, the inside radius of the inner tube, and thickness of the inner tube are 1 m, 10 mm, and 1 mm, respectively. Considering no heat exchange between the outer tube and the surrounding, the heat transfer rate for the heat exchanger is ________ W (rounded off to 1 decimal place).
A welded square plate of 1 m \(\times\) 1 m is subjected to biaxial stress of magnitude 6.5 MPa and 25 MPa, as shown in the figure below. The ratio of the normal stress acting in the perpendicular direction of the weld to the shear stress of the weld is ________ (rounded off to 2 decimal places).
A liquid comes out of the reactor of a chemical plant at 250 °C temperature with a flow rate of 100 LPM. The ambient temperature is 25 °C. Density and specific heat of the liquid remain constant at 1000 kg/m3 and 4.18 kJ/kg K, respectively, for the given range of temperature. The rate of exergy associated with the hot liquid stream at the exit of the plant is ________ kW (rounded off to 2 decimal places).
Two rectangular surfaces both having 1 m2 area are placed perpendicular to each other with a common edge. One surface is hot, having a temperature of 1000 K and emissivity of 0.4, while the other is insulated and in radiant balance with a large surrounding room at 300 K. If the fraction of radiation leaving the hot surface which reaches the cold surface is 0.2, then the equivalent overall resistance for the radiation heat loss from the hot surface is _______ m-2 (rounded off to 2 decimal places).
Comments