GATE 2005 Mechanical Engineering (ME) Question Paper with Answer Key pdf is available for download. The exam was conducted by IIT Bombay . The question paper comprised a total of 85 questions from General Aptitude and Mechanical Engineering (ME) topics.
GATE 2005 Mechanical Engineering (ME) Question Paper with Answer Key PDF
GATE 2005 Mechanical Engineering (ME) Question Paper PDF
GATE 2005 Mechanical Engineering (ME) Answer Key PDF
An inward flow reaction turbine, having an outer diameter of \(1\) m, runs at \(600\) RPM. The normal component of absolute velocity at the inlet is \(10\) m/s. If the guide blade angle is \(15^{\circ}\), then the inlet vane angle of the runner is ________ degree (rounded off to 1 decimal place).
Convective heat transfer coefficients for Fluid 1 and Fluid 2 in a heat exchanger, as shown in the figure below, are 50 W/(m2K) and 80 W/(m2K), respectively. The inner tube is made of a material which has a thermal conductivity 386 W/(m K) for the given range of temperatures in the heat exchanger. The length of the heat exchanging surface, the inside radius of the inner tube, and thickness of the inner tube are 1 m, 10 mm, and 1 mm, respectively. Considering no heat exchange between the outer tube and the surrounding, the heat transfer rate for the heat exchanger is ________ W (rounded off to 1 decimal place).
A drill bit during its lifetime can produce \(150\) through holes in a plate at a drill speed of \(200\) RPM. If the drill speed increases to \(300\) RPM, it can produce \(60\) through holes in the same plate before the drill bit fails. Assuming all other parameters remain constant, the value of the exponent in Taylor's tool life equation is ________ (rounded off to 2 decimal places).
The inventory holding cost of an item is Rs. \(0.50\) per unit per month and the ordering cost per order is Rs. \(550\). A stockist needs to supply \(10000\) units of the item per year to the customers. Assume demand is fixed and the shortage cost is infinite. Using the classical economic order quantity (EOQ) model, the optimal lot size is ________ units per order (rounded off to the nearest integer).
A rigid closed vertical cylindrical vessel of 15 cm diameter contains 5 kg water at 80 °C with 10% quality. The water is heated till its temperature reaches 130 °C. Considering only a horizontal separated interface between liquid and vapor, the dip in the liquid level after the heating process is ________ cm (rounded off to 2 decimal places). Properties of water at various saturation temperatures are given in the table below.
T (°C)
vf (m3/kg)
vg (m3/kg)
uf (kJ/kg)
ug (kJ/kg)
80
0.001029
3.4053
334.97
2481.60
130
0.001070
0.66808
546.10
2539.50
T, v, and u are temperature, specific volume, and specific internal energy, respectively. Subscripts f and g represent saturated liquid and saturated vapor, respectively.
A cylindrical pressure vessel made of steel has diameter of 3 m and wall thickness of 15 mm. For steel, Young's modulus and Poisson's ratio are 210 GPa and 0.3, respectively. The cylinder is designed such that the allowable normal strain at the outer cylindrical surface is equal to 0.00034. The permissible pressure in the tank is ________ kPa (rounded off to 1 decimal place).
Comments