GATE 2017 Physics (PH) Question Papers with Answer Key PDFs (February 5-Afternoon Session) is now available for download. GATE 2017 PH was conducted by IIT Roorkee. GATE 2017 PH had a moderate difficulty level. The paper was conducted for a total of 100 marks with a total of 65 questions.
There were 30 questions for 1 mark each and the rest of the questions contains 2 Mark each. Also for 1 marks question 0.33 was deducted for a wrong answer, and For 2 Marks question negative marking was 0.66. in GATE PH Paper.
In a deep drawing operation of a rectangular sheet metal, \(30\%\) stretching in length results in \(15\%\) reduction in thickness. Assuming volume constancy, the normal anisotropy of the sheet metal is ________ (rounded off to 2 decimal places).
The activities of a PERT network and their corresponding activity time estimates (in weeks), namely optimistic (\(t_o\)), most likely (\(t_m\)), and pessimistic (\(t_p\)), are given in the table below.
Activity
\(t_o\)
\(t_m\)
\(t_p\)
1-2
2
4
12
1-3
2
4
6
1-4
3
4
11
2-5
3
6
9
3-4
2
5
14
3-5
3
3
3
4-5
3
6
15
5-6
2
5
8
The expected project length is ________ weeks (in integer).
The actual demand for castings in a factory is \(500\) units and \(635\) units for the months of January 2026 and February 2026, respectively. The forecasted demand for January 2026 is \(250\) units and the smoothing constant is \(0.7\). Using the exponential smoothing method, the forecast of the demand for castings in March 2026 is ________ units (in integer).
Convective heat transfer coefficients for Fluid 1 and Fluid 2 in a heat exchanger, as shown in the figure below, are 50 W/(m2K) and 80 W/(m2K), respectively. The inner tube is made of a material which has a thermal conductivity 386 W/(m K) for the given range of temperatures in the heat exchanger. The length of the heat exchanging surface, the inside radius of the inner tube, and thickness of the inner tube are 1 m, 10 mm, and 1 mm, respectively. Considering no heat exchange between the outer tube and the surrounding, the heat transfer rate for the heat exchanger is ________ W (rounded off to 1 decimal place).
Two rectangular surfaces both having 1 m2 area are placed perpendicular to each other with a common edge. One surface is hot, having a temperature of 1000 K and emissivity of 0.4, while the other is insulated and in radiant balance with a large surrounding room at 300 K. If the fraction of radiation leaving the hot surface which reaches the cold surface is 0.2, then the equivalent overall resistance for the radiation heat loss from the hot surface is _______ m-2 (rounded off to 2 decimal places).
The inventory holding cost of an item is Rs. \(0.50\) per unit per month and the ordering cost per order is Rs. \(550\). A stockist needs to supply \(10000\) units of the item per year to the customers. Assume demand is fixed and the shortage cost is infinite. Using the classical economic order quantity (EOQ) model, the optimal lot size is ________ units per order (rounded off to the nearest integer).
Comments