GATE 1993 Electrical Engineering (EE) Question Paper with Answer Key pdf is available for download. The exam was conducted by IIT Bombay. The question paper comprised a total of 25 questions from General Aptitude and Electrical Engineering (EE) topics.
GATE 1993 Electrical Engineering (EE) Question Paper with Answer Key PDF
GATE 1993 Electrical Engineering (EE) Question Paper PDF
GATE 1993 Electrical Engineering (EE) Answer Key PDF
Two rectangular surfaces both having 1 m2 area are placed perpendicular to each other with a common edge. One surface is hot, having a temperature of 1000 K and emissivity of 0.4, while the other is insulated and in radiant balance with a large surrounding room at 300 K. If the fraction of radiation leaving the hot surface which reaches the cold surface is 0.2, then the equivalent overall resistance for the radiation heat loss from the hot surface is _______ m-2 (rounded off to 2 decimal places).
A welded square plate of 1 m \(\times\) 1 m is subjected to biaxial stress of magnitude 6.5 MPa and 25 MPa, as shown in the figure below. The ratio of the normal stress acting in the perpendicular direction of the weld to the shear stress of the weld is ________ (rounded off to 2 decimal places).
An inward flow reaction turbine, having an outer diameter of \(1\) m, runs at \(600\) RPM. The normal component of absolute velocity at the inlet is \(10\) m/s. If the guide blade angle is \(15^{\circ}\), then the inlet vane angle of the runner is ________ degree (rounded off to 1 decimal place).
A drill bit during its lifetime can produce \(150\) through holes in a plate at a drill speed of \(200\) RPM. If the drill speed increases to \(300\) RPM, it can produce \(60\) through holes in the same plate before the drill bit fails. Assuming all other parameters remain constant, the value of the exponent in Taylor's tool life equation is ________ (rounded off to 2 decimal places).
Convective heat transfer coefficients for Fluid 1 and Fluid 2 in a heat exchanger, as shown in the figure below, are 50 W/(m2K) and 80 W/(m2K), respectively. The inner tube is made of a material which has a thermal conductivity 386 W/(m K) for the given range of temperatures in the heat exchanger. The length of the heat exchanging surface, the inside radius of the inner tube, and thickness of the inner tube are 1 m, 10 mm, and 1 mm, respectively. Considering no heat exchange between the outer tube and the surrounding, the heat transfer rate for the heat exchanger is ________ W (rounded off to 1 decimal place).
In a deep drawing operation of a rectangular sheet metal, \(30\%\) stretching in length results in \(15\%\) reduction in thickness. Assuming volume constancy, the normal anisotropy of the sheet metal is ________ (rounded off to 2 decimal places).
Comments